16" mid-length gas Ar15 Listing ID: 3027885

16" Midlength Ar15

Built this rifle for my youngest son, but he wants a higher end rifle. Lol. This was a 16" Carbine upper from Palmetto State Armory. Bought the carbine by mistake. I bought a Midlength gas, Ballistic Advantage barrel and swapped it over. Lower was built with an Anderson lower. Has a nice 2-stage trigger. Has approx 10rds through it to sight in the MBUS sights. Front sight is on backwards because like a LOT of makers, Palmetto State Armory doesn't have a slot at the end of the top rail so it doesn't sit flush with the end of the handguard.


Upper List:

(PSA means Palmetto State Armory)

PSA upper receiver (Upper was assembled by PSA)
PSA Bolt Carrier Group 5.56 Full-Auto Nitride MPI
PSA Free float light weight handguard
PSA low profile gas block and Ballistic Advantage gas tube
16" Ballistic Advantage Midlength Nitride barrel
Magpul Gen2 flip up sights (front sight is backwards on purpose. Doesn't sit flush to the end of the handguard in normal configuration)

Lower List:

Anderson lower (rear take down uses a 4-40 set screw to keep detent captive)
Schmid NiB two stage trigger (2.5lb 1st stage 2lb second stage)
Anderson QD Waffle stock and A2 grip
7075 mil spec buffer tube/castle nut/end plate (castle nut unstaked)
Kaw Valley Carbine spring
Noveske H buffer
Ambi Safety
A2 grip
Magpul trigger guard
Dimpled take down pins
PSA Lower parts kit for rest of small parts
2 new in wrapper Magpul MOE 30rd magazines


Asking $650 as it is now, or $575 minus the 2-stage trigger and ambi safety. Let me know ahead of time if you don't want those items.

I'm in South Austin and won't travel further than I-35/Slaughter or Mopac/SLaughter Lane. Will meet anywhere between those. With enough notice can do Cabelas in Buda. Will only take cash and will need to see a valid Tx drivers license to prove age/residency. Only available Sunday early afternoon to evening. Can possibly do meet up Mon or Tue depending on when and where.